Ford 2011 F-150 v.2 Manuel d'utilisateur télécharger pdf (Page 100)

100

101

The power point can switch to a fault mode when it is overloaded,

overheated, or shorted. For overloading and shorting conditions, unplug

your device and turn the ignition key off then on. For an overheating

condition, let the system cool off, then turn the ignition key off then on.

The 110V AC power point can provide power whenever the vehicle

ignition is in the on position and the power point green indicator light

located in the top left corner is turned on. Refer to the indicator light

code below for the power point status.

Indicator light codes

Green light is on — Power point is ready to supply power

Green light is off — Power point power supply is off. Ignition is not in

the on position

Green light is blinking — Power point is in fault mode

Note: The 110V AC power point will turn off after 13 minutes if the

ignition is in the on position without the engine running. Keep the

engine running or cycle the ignition before the 13 minute time-out to

keep the inverter on.

Ashtray (if equipped)

The ashtray is located on the

instrument panel.

To open ashtray, push in on the

door and release. The ashtray

assembly will tip out. To close, push

assembly in completely and release.

Up-level ashtray shown; base

similar.

POWER WINDOWS (IF EQUIPPED)

WARNING: Do not leave children unattended in the vehicle and

do not let children play with the power windows. They may

seriously injure themselves.

WARNING: When closing the power windows, you should verify

they are free of obstructions and ensure that children and/or

pets are not in the proximity of the window openings.

Driver Controls

100

2011 F-150 (f12)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 459 460

Commentaires sur ces manuels

Pas de commentaire

Ford 2011 F-150 v.2 Manuel d'utilisateur Page 100

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2011 F-150 v.2