Ford 2011 Explorer v.2 Manuel d'utilisateur Page 310

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 448
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 309
including zero mph. BLIS is also active if the transmission is placed in N
(Neutral). If the transmission is shifted out of D (Drive) or N (Neutral)
the system will enter the CTA mode (see CTA operation below). Once
shifted back in to D (Drive) the BLIS mode will activate once driven
above 3 mph (5 km/h).
The BLIS will trigger the alert for vehicles that enter your blind zone
from the rear or merge in to the blind zone from the side. Vehicles that
you pass, or a vehicle that enters the blind zone from the front, will
trigger the alert only after the vehicle is present in the blind zone for
three seconds. Note: For vehicles that pass through the blind zone
quickly, typically less than two seconds, the BLIS will not illuminate the
alert.
The BLIS consists of two radar
sensors each located rearward of
the rear wheels hidden behind the
bumper fascia. Do not place any
type of bumper sticker in this area.
Note: The BLIS typically will not
detect parked vehicles, humans,
animals, or infrastructure (fences,
guard rails, trees, etc.). The BLIS
does not function when the transmission is in R (Reverse) or P (Park).
The BLIS does not provide any additional warning when your turn
signal is activated.
BLIS detection limitations: Due to the nature of radar technology,
there may be certain instances where vehicles entering and exiting the
blind spot zones may not be detected. Below is a list of circumstances
that may cause non-detection:
Debris build-up on the rear quarter panel fascias
Certain maneuvering of vehicles entering and exiting the blind zone
Vehicles passing through the blind zone at very fast rates
Severe weather conditions
When several vehicles forming a convoy pass through the blind zone.
BLIS False Alerts
Due to the nature of radar technology, there may be certain instances
when the BLIS will alert with no object present in the blind zone. This
is known as a false alert. Some level of false alerts are normal.
Circumstances that may cause a false alert are; guardrails, freeway
Driving
310
2011 Explorer (exp)
Owners Guide, 3rd Printing
USA (fus)
Vue de la page 309
1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 447 448

Commentaires sur ces manuels

Pas de commentaire