Ford 2011 Explorer v.1 Manuel d'utilisateur télécharger pdf (Page 141)

100

101

Power door lock switch autolock enable/disable procedure

Before starting, ensure the ignition is off and all vehicle doors are closed.

You must complete Steps 1–5 within 30 seconds or the procedure will

have to be repeated. If the procedure needs to be repeated, wait a

minimum of 30 seconds before beginning again.

1. Turn the ignition on.

2. Press the power door unlock

control on the door panel three

times.

3. Turn the ignition off.

4. Press the power door unlock

control on the door panel three

times.

5. Turn the ignition back on. The

horn will chirp one time to confirm

programming mode has been entered and is active.

6. To enable/disable the autolock feature, press the unlock control, then

press the lock control. The horn will chirp once if autolock was

deactivated or twice (one short and one long chirp) if autolock was

activated.

7. Turn the ignition off. The horn will chirp once to confirm the

procedure is complete.

Autounlock feature (if enabled)

The autounlock feature will unlock all the doors when:

• the ignition is on, all the doors are closed, and the vehicle has been in

motion at a speed greater than 12 mph (20 km/h);

• the vehicle has then come to a stop and the ignition is turned off or to

accessory; and

• the driver door is opened within 10 minutes of the ignition being

turned off or to accessory.

Note: The doors will not autounlock if the vehicle has been

electronically locked after the ignition is turned off and before the driver

door is opened.

Locks and Security

140

2011 Explorer (exp)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 448 449

Commentaires sur ces manuels

Pas de commentaire

Ford 2011 Explorer v.1 Manuel d'utilisateur Page 141

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2011 Explorer v.1