Ford 2011 Escape v.2 Manuel d'utilisateur télécharger pdf (Page 104)

To replace the battery:

1. Twist a thin coin in the slot of the

IKT near the key ring in order to

remove the battery cover.

Note: Do not wipe off any grease on

the battery terminals on the back

surface of the circuit board.

2. Remove the old battery.

Note: Please refer to local

regulations when disposing of

transmitter batteries.

3. Insert the new battery. Refer to

the instructions inside the IKT for

the correct orientation of the

battery. Press the battery down to

ensure that the battery is fully

seated in the battery housing cavity.

4. Snap the battery cover back onto

the key.

Note: Replacement of the battery will not cause the IKT to become

deprogrammed from your vehicle. The IKT should operate normally after

battery replacement.

Replacing lost Integrated Keyhead Transmitters (IKTs)

If you would like to have your Integrated Keyhead Transmitters

reprogrammed because you lost one, or would like to buy additional

IKTs, you can either reprogram them yourself, or take all IKTs to your

authorized dealer for reprogramming.

How to reprogram your Integrated Keyhead Transmitters (IKTs)

To program a new Integrated Keyhead Transmitter yourself, refer to

Programming spare keys in the SecuriLock威 passive anti-theft section

of this chapter. Note: At least two IKTs are required to perform this

procedure yourself.

Illuminated entry

The interior lamps, parking lamps and puddle lamps (if equipped)

illuminate when the Integrated Keyhead Transmitter or the keyless entry

system keypad is used to unlock the door(s).

Locks and Security

104

2011 Escape (204)

Owners Guide, 2nd Printing

USA (fus)

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 363 364

Pas de commentaire

Ford 2011 Escape v.2 Manuel d'utilisateur Page 104