Ford 2010 Taurus v.3 Manuel d'utilisateur télécharger pdf (Page 108)

100

101

Note: The Car2U威 system allows for three devices to be programmed. If

you need to change or replace any of the three devices after it has been

initially programmed, it is necessary to erase the current settings using

the Erasing the Car2U威 Home Automation System buttons procedure

and then programming all of the devices being used.

Fixed code programming

Note: Do not program the Car2U威 system with the vehicle in the garage.

Make sure that your key is on and engine off while programming the

transmitter.

1. To program units with fixed code DIP switches, you will need the

garage door hand-held transmitter, paper and a pen or pencil.

2. Open the battery cover and record the switch settings from left to

right for all 8 to 12 switches. Use the figure below:

When a switch is in the up, on, or + position, circle “L.”

When a switch is in the middle, neutral, or 0 position, circle “M.”

When a switch is in the down, off, or – position, circle “R.”

Switch

position 1234567 8 9101112

Up,onor+ LLLLLLLLLLLL

Middle,

neutralor0

MMMMMMMMMMMM

Down, off or – RRRRRRRRRRRR

L=left; M=middle; R=right

Driver Controls

108

2010 Taurus (500)

Owners Guide, 3rd Printing

USA (fus)

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 387 388

Commentaires sur ces manuels

Pas de commentaire

Ford 2010 Taurus v.3 Manuel d'utilisateur Page 108

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2010 Taurus v.3