Ford 2010 Ranger v.1 Manuel d'utilisateur télécharger pdf (Page 262)

2. While the engine idles, turn the steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the reservoir. It should be between the MIN

and MAX lines. Do not add fluid if the level is within this range.

5. If the fluid is low, add fluid in small amounts, until it reaches between

the MIN and MAX lines. Refer to Maintenance product specifications

and capacities in this chapter for the proper fluid type.

BRAKE FLUID

The fluid level will drop slowly as

the brakes wear, and will rise when

the brake components are replaced.

Fluid levels between the MIN and

MAX lines are within the normal

operating range; there is no need to

add fluid. If the fluid levels are

outside of the normal operating

range, the performance of the

system could be compromised; seek

service from your authorized dealer

immediately.

CLUTCH FLUID (IF EQUIPPED)

Check the fluid level. Refer to scheduled maintenance information for

the service interval schedules.

During normal operation, the fluid level in the clutch reservoir should

remain constant. If the fluid level drops, refill the fluid level to the step

in the reservoir.

Use only a DOT 3 brake fluid designed to meet Ford specifications. Refer

to Maintenance product specifications and capacities in this chapter.

WARNING: Carefully read cautionary information on product

label. For MEDICAL EMERGENCY INFORMATION contact a

physician or Poison Control Center immediately; on Ford-Motorcraft

products call: 1-800-959-3673 (FORD). Failure to follow these

instructions may result in personal injury.

Maintenance and Specifications

262

2010 Ranger (ran)

Owners Guide, 1st Printing

USA (fus)

1 2 ... 257 258 259 260 261 262 263 264 265 266 267 ... 285 286

Pas de commentaire

Ford 2010 Ranger v.1 Manuel d'utilisateur Page 262