Ford 2010 Fusion v.1 Manuel d'utilisateur télécharger pdf (Page 22)

System check

Selecting this function from the

SETUP menu causes the message

center to cycle through each of the

systems being monitored.

Pressing the RESET control cycles

the message center through each of the systems being monitored.

Some monitored systems show a message only if a warning is present.

The sequence of the system check report is as follows:

1. XXX% OIL LIFE

2. All DOORS CLOSED

3. TRUNK CLOSED

4. BLIND SPOT SYSTEM (if equipped)

5. CROSS TRAFFIC SYSTEM (if equipped)

6. BRAKE SYSTEM

7. FUEL LEVEL

Oil Life XXX%

An oil change is required whenever indicated by the message center and

according to the recommended maintenance schedule. USE ONLY

RECOMMENDED ENGINE OILS.

To reset the oil monitoring system to 100% after each oil change

(approximately 7,500 miles [12,000 km] or 12 months) perform the

following:

1. Press and release the SETUP

control to display “OIL LIFE XXX%

HOLD RESET = NEW”.

2. Press and hold RESET for two

seconds and release. Oil life is set to

100% and “OIL LIFE SET TO 100%”

is displayed.

Note: To change oil life 100% miles value from 7,500 miles (12,000 km)

or 12 months to another value, proceed to Step 3.

2010 Fusion (fsn)

Owners Guide, 1st Printing

USA (fus)

Instrument Cluster

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 337 338

Pas de commentaire

Ford 2010 Fusion v.1 Manuel d'utilisateur Page 22