Ford 2008 F-550 v.2 Manuel d'utilisateur télécharger pdf (Page 139)

Note: The autounlock feature can be activated/deactivated

independently of the autolock feature.

Power door lock switch autounlock enable/disable procedure

Before starting, ensure the ignition is in the 1 (OFF/LOCK) position and

all vehicle doors are closed. You must complete Steps 1–5 within 30

seconds or the procedure will have to be repeated. If the procedure

needs to be repeated, wait a minimum of 30 seconds before beginning

again.

1. Place the key in the ignition and

turn the ignition to the 3 (ON)

position.

2. Press the power door unlock

control on the door panel three

times.

3. Turn the ignition from the 3 (ON)

position to the 1 (OFF/LOCK)

position.

4. Press the power door unlock control on the door panel three times.

5. Turn the ignition back to the 3 (ON) position. The horn will chirp one

time to confirm programming mode has been entered and is active.

6. To enable/disable the autounlock feature, press the lock control, then

press the unlock control. The horn will chirp once if autounlock was

deactivated or twice (one short and one long chirp) if autounlock was

activated.

7. Turn the ignition to the 1 (OFF/LOCK) position. The horn will chirp

once to confirm the procedure is complete.

Keyless entry key pad autounlock enable/disable procedure

1. Turn the ignition to the 1

(OFF/LOCK) position.

2. Close all the doors.

3. Enter factory–set 5–digit entry

code.

4. Press and hold the 3 • 4. While holding the 3 • 4, press and release

the 7 • 8. While still holding the 3 • 4, press and release the 7 • 8a

second time.

5. Release the 3 • 4.

2008 F-250/350/450/550 (f23)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

139

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 367 368

Pas de commentaire

Ford 2008 F-550 v.2 Manuel d'utilisateur Page 139