Ford 2008 Escape v.1 Manuel d'utilisateur télécharger pdf (Page 257)

• 3.0L DOHC V6 Duratec engine

• If required, add engine oil to the engine. Refer to Adding engine oil

in this chapter.

• Do not overfill the engine with oil. Oil levels above the MAX

mark or upper hole may cause engine damage. If the engine is

overfilled, some oil must be removed from the engine by an authorized

dealer.

7. Put the indicator back in and ensure it is fully seated.

Adding engine oil

1. Check the engine oil. For instructions, refer to Checking the engine

oil in this chapter.

2. If the engine oil level is not within the normal range, add only certified

engine oil of the recommended viscosity. Remove the engine oil filler cap

and use a funnel to pour the engine oil into the opening.

3. Recheck the engine oil level. Make sure the oil level is not above the

MAX or FULL mark on the engine oil level indicator (dipstick).

4. Install the indicator and ensure it is fully seated.

5. Fully install the engine oil filler cap by turning the filler cap clockwise

1/4 of a turn until it is seated.

To avoid possible oil loss, DO NOT operate the vehicle with the

engine oil level indicator and/or the engine oil filler cap removed.

2008 Escape (204)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

257

1 2 ... 252 253 254 255 256 257 258 259 260 261 262 ... 295 296

Pas de commentaire

Ford 2008 Escape v.1 Manuel d'utilisateur Page 257