Ford 2007 Ranger v.2 Manuel d'utilisateur télécharger pdf (Page 254)

1. Start the engine and let it run until it reaches normal operating

temperature (the engine coolant temperature gauge indicator will be

near the center of the normal area between H and C).

2. While the engine idles, turn the steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the reservoir. It should be between the MIN

and MAX lines. Do not add fluid if the level is within this range.

5. If the fluid is low, add fluid in small amounts, until it reaches between

the MIN and MAX lines.

BRAKE FLUID

The fluid level will drop slowly as

the brakes wear, and will rise when

the brake components are replaced.

Fluid levels between the “MIN” and

“MAX” lines are within the normal

operating range; there is no need to

add fluid. If the fluid levels are

outside of the normal operating

range the performance of the

system could be compromised; seek

service from your authorized dealer

immediately.

CLUTCH FLUID (IF EQUIPPED)

Check the fluid level. Refer to scheduled maintenance information for

the service interval schedules.

During normal operation, the fluid level in the clutch reservoir should

remain constant. If the fluid level drops, refill the fluid level to the step

in the reservoir.

Use only a DOT 3 brake fluid designed to meet Ford specifications. Refer

to Maintenance product specifications and capacities in this chapter.

Carefully read cautionary information on product label. For

MEDICAL EMERGENCY INFORMATION contact a physician or

Poison Control Center immediately; on Ford-Motorcraft products call:

1-800-959-3673 (FORD). Failure to follow these instructions may result

in personal injury.

2007 Ranger (ran)

Owners Guide (post-2002-fmt)

USA (fus)

Maintenance and Specifications

254

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 279 280

Pas de commentaire

Ford 2007 Ranger v.2 Manuel d'utilisateur Page 254