Ford 2007 Escape v.1 Manuel d'utilisateur télécharger pdf (Page 83)

Illuminated exit

• The interior lights will illuminate when the key is removed from the

ignition.

The lamps automatically turn off after 25 seconds. The dome and cargo

lamp controls must not be set to the OFF position for the illuminated

exit system to operate.

KEYLESS ENTRY SYSTEM (IF EQUIPPED)

You can use the keyless entry

keypad to lock or unlock the doors

without using a key.

The keypad can be operated with

the factory set 5–digit entry code;

this code is located on the owner’s wallet card in the glove box and is

available from your authorized dealer. You can also create your own

5–digit personal entry code.

When pressing the controls on the keypad, press the middle of the

controls to ensure a good activation.

Anti-scan feature

If an incorrect code has been entered 7 times (35 consecutive button

presses), the keypad will go into an anti-scan mode. This mode disables

the keypad for one minute and the keypad lamp will flash during this

time.

The anti-scan feature will turn off after:

• one minute of keypad inactivity.

• pressing the

control on the remote entry transmitter.

• the ignition is turned to the 3 (RUN) position.

Programming a personal entry code

To create your own personal entry code:

1. Enter the factory set code. Note: The keyless entry keypad and

interior lights will illuminate and the driver’s door will unlock.

2. Within five seconds press the 1 • 2 on the keypad.

3. Enter your personal 5-digit code. Each number must be entered

within five seconds of each other.

4. The doors will again lock then unlock, to confirm that your personal

keycode has been programmed to the module.

2007 Escape (204)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 287 288

Pas de commentaire

Ford 2007 Escape v.1 Manuel d'utilisateur Page 83