Ford 2006 Expedition v.2 Manuel d'utilisateur télécharger pdf (Page 144)

100

101

Deactivating the memory seat feature

To deactivate this feature:

1. Press the SET control on the driver’s door panel.

2. Within 5 five seconds, press any control on the remote transmitter

which you would like to deactivate and then press the SET control on

the driver’s door panel.

3. Repeat this procedure for another remote transmitter if desired.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium

battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the two

halves of the remote entry

transmitter near the key ring. DO

NOT TAKE THE RUBBER COVER

AND CIRCUIT BOARD OFF THE

FRONT HOUSING OF THE

REMOTE ENTRY TRANSMITTER.

2. Do not wipe off any grease on the

battery terminals on the back

surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when

disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry

transmitter for the correct orientation of the battery. Press the battery

down to ensure that the battery is fully seated in the battery housing

cavity.

5. Snap the two halves back together.

2006 Expedition (exd)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

144

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 367 368

Commentaires sur ces manuels

Pas de commentaire

Ford 2006 Expedition v.2 Manuel d'utilisateur Page 144

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2006 Expedition v.2