Ford 2006 Escape v.1 Manuel d'utilisateur télécharger pdf (Page 113)

The driver and front passenger BeltMinder娂 features can be

deactivated/activated by performing the following procedure:

Before following the procedure, make sure that:

• The parking brake is set

• The gearshift is in P (Park)

• The ignition switch is in the OFF position

• The driver and front passenger safety belts are unbuckled

To reduce the risk of injury, do not deactivate/activate the Belt

Minder feature while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1

minute)

• Step 3 must be completed within 50 seconds after the safety belt

warning light turns off.

3. For the seating position being disabled, buckle then unbuckle the

safety belt 9 times, ending in the unbuckled state. (Step 3 must be

completed within 50 seconds after the safety belt warning light turns

off.)

• After Step 3, the restraint system warning light (airbag light) will be

turned on for three seconds.

4. Within 10 seconds of the light turning on, buckle then unbuckle the

safety belt.

• This will disable the BeltMinder娂 feature for that seating position if it

is currently enabled. As confirmation, the restraint system warning

light will flash 4 times per second for 3 seconds.

• This will enable the BeltMinder娂 feature for that seating position if it

is currently disabled. As confirmation, the restraint system warning

light will flash 4 times per second for 3 seconds, followed by 3

seconds with the light off, then followed by the restraint system

warning light flashing 4 times per second for 3 seconds again.

• After receiving confirmation, the deactivation/activation procedure is

complete.

2006 Escape (204)

Owners Guide (post-2002-fmt)

USA (fus)

Seating and Safety Restraints

113

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 287 288

Pas de commentaire

Ford 2006 Escape v.1 Manuel d'utilisateur Page 113