Ford 2005 F-550 v.1 Manuel d'utilisateur télécharger pdf (Page 42)

Flash to pass

Pull toward you slightly to activate

and release to deactivate.

PANEL DIMMER CONTROL

Use to adjust the brightness of the

instrument panel and all applicable

switches in the vehicle during

headlamp and parklamp operation.

Move the control to the full upright

position, past detent, to turn on the

interior lamps.

AIMING THE HEADLAMPS

Your vehicle may be equipped with a sealed beam or aerodynamic

headlamp system. Sealed beam headlamps may be aimed in the vertical

(up/down) and the horizontal (left/right) directions using the procedures

following. The aerodynamic headlamps can only be aimed in the vertical

direction (up/down) using the procedures following. The headlamps on

your vehicle are properly aimed at the assembly plant and should not

normally need adjusting.

Vertical and horizontal aim adjustment (sealed beam headlamps)

The headlamps on your vehicle are intended to be aimed using

mechanical aimers. If mechanical aimers are utilized, and a universal

headlamp adaptor is not available (in other words only the base,

non-adjustable 6x8 sealed beam adaptor is available) and the cross-car

sight line is in any way blocked, Ford Motor Company will supply a pair

of spacer blocks at no cost. Please contact your dealer. If a universal

adaptor is available and the cross-car sight line is in any way blocked, set

the legs of the universal adaptor all to the same setting, such that the

cross-car sight line is no longer blocked, per the instructions for the

brand of mechanical aimer employed. You can also aim the headlamps

visually using the procedure set forth below.

REVIEW COPY

2005 F250/350/450/550 (f23), Owners Guide (post-2002-fmt) (own2002),

Market: USA_English (fus)

Lights

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 303 304

Pas de commentaire

Ford 2005 F-550 v.1 Manuel d'utilisateur Page 42