Ford 2003 Thunderbird v.1 Manuel d'utilisateur télécharger pdf (Page 176)

Allow the vehicle to sit for at least eight hours without starting the

engine. Then, start the engine and complete the above driving cycle. The

engine must warm up to its normal operating temperature. Once started,

do not turn off the engine until the above driving cycle is complete.

POWER STEERING FLUID

Refer to the scheduled maintenance guide for the service interval

schedules. If adding fluid is necessary, use only MERCON威 ATF.

1. Start the engine and let it run

until it reaches normal operating

temperature (the engine coolant

temperature gauge indicator will be

near the center of the normal area

between H and C).

2. While the engine idles, turn the

steering wheel left and right several

times.

3. Turn the engine off.

4. Check the fluid level in the

reservoir. It should be between the

MIN and MAX lines. Do not add

fluid if the level is in this range.

5. If the fluid is low, add fluid in

small amounts, continuously

checking the level until it reaches

the range between the MIN and

MAX lines. Be sure to put the cap

back on the reservoir.

BRAKE FLUID RESERVOIR

The fluid level will drop slowly as

the brakes wear, and will rise when

the brake components are replaced.

Fluid levels between the “MIN” and

“MAX” lines are within the normal

operating range, there is no need to

add fluid. If the fluid levels are

outside of the normal operating range, the performance of your brake

system could be compromised, seek service from your dealer

immediately.

Maintenance and Specifications

176

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 199 200

Pas de commentaire

Ford 2003 Thunderbird v.1 Manuel d'utilisateur Page 176