Ford 2002 F-250 Manuel d'utilisateur télécharger pdf (Page 113)

To start the vehicle:

1. Make sure the parking brake is fully set.

2. Press the clutch pedal to the floor, then put the gearshift lever in the

neutral position.

3. Start the engine, then press the brake pedal and release the parking

brake.

4. Move the gearshift lever to the desired gear, then slowly release the

clutch pedal while slowly pressing on the accelerator.

Do not drive with your foot resting on the clutch pedal or use the clutch

pedal to hold your vehicle at a standstill while waiting on a hill. These

actions will reduce the life of the clutch.

Recommended shift speeds

Downshift according to the following charts for your specific

engine/drivetrain combination:

Maximum downshift speeds

6-speed transmission

Shift from: Transfer case position (if equipped)

2H or 4H 4L

(Overdrive) - 4

72 km/h (45 mph) 26 km/h (16 mph)

4 - 3 56 km/h (35 mph) 19 km/h (12 mph)

3 - 2 32 km/h (20 mph) 13 km/h (8 mph)

2 - 1 8 km/h (5 mph) 3 km/h (2 mph)

1 - LO Only shift to LO when at a stop.

Use 2H or 4H for 4WD equipped vehicles.

Downshift at lower speeds when driving on slippery surfaces.

Reverse

1. Make sure that your vehicle is at a complete stop before you shift into

R (Reverse). Failure to do so may damage the transmission.

2. Move the gearshift lever into the neutral position and wait at least

three seconds before shifting into R (Reverse).

• The gearshift lever can only be moved into R (Reverse) by moving it

from left of 3 (Third) and 4 (Fourth) before shifting into R (Reverse).

This is a lockout feature that protects the transmission from

accidentally being shifted into R (Reverse) from

(Overdrive).

Driving

113

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 263 264

Pas de commentaire

Ford 2002 F-250 Manuel d'utilisateur Page 113