Ford 2002 Explorer v.3 Manuel d'utilisateur télécharger pdf (Page 122)

100

101

2. Within 5 five seconds, press one control on the remote transmitter

which you would like to deactivate and then press the SET control on

the driver’s door panel.

3. Repeat this procedure for another remote transmitter if desired.

Replacing the battery

The remote transmitter is powered by one coin type three-volt lithium

battery CR2032 or equivalent. Typical operating range will allow you to

be up to 10 meters (33 feet) away from your vehicle. A decrease in

operating range can be caused by:

• weather conditions

• nearby radio towers

• structures around the vehicle

• other vehicles parked next to the vehicle

To replace the battery:

1. Twist a thin coin between the two

halves of the transmitter near the

key ring. DO NOT TAKE THE

FRONT PART OF THE

TRANSMITTER APART.

2. Place the positive (+) side of new

battery in the same orientation.

Refer to the diagram inside the

transmitter unit.

3. Snap the two halves back

together.

Replacement of the battery will not cause the remote transmitter to

become deprogrammed from your vehicle. The remote transmitter should

operate normally after battery replacement.

Controls and features

122

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 335 336

Commentaires sur ces manuels

Pas de commentaire

Ford 2002 Explorer v.3 Manuel d'utilisateur Page 122

Commentaires sur ces manuels

Produits connexes et manuels pour Voitures Ford 2002 Explorer v.3