Ford 2000 Windstar Manuel d'utilisateur Page 247

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 280
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 246
4. Use an E8 Torx socket to turn the horizontal adjusting screw until the
“0” mark on the yellow dial lines up with the reference mark on the
marker (as shown) when viewed directly from above.
5. When the horizontal aim has been adjusted, close the hood.
Vertical aim adjustment
The numbers shown on the vial indicate beam direction in degrees up or
down.
1. Park the vehicle on a level
surface
2. Locate the bubble level vertical
aim indicator located on the bottom
shelf of the headlamp reflector,
visible through the headlamp lens.
3. With the hood open, locate the
vertical adjusting screw on the outer
top of the headlamp.
4. Using an E8 Torx socket rotate
the adjusting screw until the bubble
in the vial is centered between the
two white lines (which represent
the “0” mark) when viewed from the
front of the lens.
5. When the horizontal and vertical
indicators are set to the “0” mark, the headlamp has been properly
aimed.
6. Close the hood.
D
U
Maintenance and care
247
Vue de la page 246
1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 279 280

Commentaires sur ces manuels

Pas de commentaire