Ford 2000 Explorer Manuel d'utilisateur télécharger pdf (Page 255)

If the bulb is accidentally touched, it should be cleaned with rubbing

alcohol before being used.

1. With the flat side of the new bulb’s plastic base facing upward, insert

the glass end of the bulb into the lamp assembly. You may need to turn

the bulb left or right to align the grooves in the plastic base with the

tabs in the lamp assembly. When the grooves are aligned, push the bulb

into the lamp assembly until the plastic base contacts the rear of the

lamp assembly.

2. Install the bulb retaining ring over the plastic base until it contacts the

rear of the socket by rotating clockwise until you feel a “stop.”

3. Install the electrical connector into the rear of the plastic base until it

snaps, locking it into position.

4. Turn the headlamps on and make sure they work properly. If the

headlamp was correctly aligned before you changed the bulb, you should

not need to align it again.

Replacing front parking lamp/turn signal/sidemarker bulbs

5. Remove two screws from the

lamp assembly.

6. Disengage lamp assembly.

7. Rotate bulb socket

counterclockwise and remove from

lamp assembly.

8. Carefully pull bulb straight out of

socket and push in the new bulb.

9. Install bulb socket in lamp

assembly by turning clockwise.

10. Align the parking lamp studs

with the plastic grommets on the

vehicle and push to snap in place.

11. Install two screws on lamp assembly.

Maintenance and care

255

1 2 ... 250 251 252 253 254 255 256 257 258 259 260 ... 295 296

Pas de commentaire

Ford 2000 Explorer Manuel d'utilisateur Page 255