Ford RACING M-6007-X302E Manuel d'utilisateur télécharger pdf (Page 10)

M-6007-X302E

340 HP Crate Engine

GUIDE

NO PART OF THIS DOCUMENT MAY BE REPRODUCED WITHOUT PRIOR AGREEMENT AND WRITTEN PERMISSION OF

FORD RACING PERFORMANCE PARTS.

Techline 1-800-367-3788 Page 10 of 13 IS-1850-0289

Factory Ford shop manuals are available from Helm Publications, 1-800-782-4356

The next step is checking bellhousing bore runout. You are checking to see if the bellhousing bore centerline is

aligned with crankshaft centerline. Reposition the dial indicator in the bellhousing bore (as shown in Fig. 3). Rotate

the crankshaft and mark down the readings. Maximum out of concentricity is .015. If the bore runout is out of spec.,

install appropriate offset dowels.

Offset alignment dowels can be purchased from Lakewood.

.007 PN 15950

.014 PN 15960

.021 PN 15970

Fig. 2 Fig. 3

FLYWHEELS

The M-6007-X302E comes with a "0" balance 157-tooth billet steel flywheel. Your transmission application may

need a different flywheel than the one that came with your crate engine. See the flywheel page of the catalog or call

the Tech Line at (800) 367-3788.

IGNITION SYSTEM

The M-6007-X302E does not include a distributor. The distributor you select must have a steel distributor gear to be

compatible with the hydraulic roller camshaft. Distributor gear M-12390-B for carbureted application or F for EFI

application recommended.

NOTE: See engine tips sheet for recommended ignition timing.

1 2 ... 5 6 7 8 9 10 11 12 13

Pas de commentaire

Ford RACING M-6007-X302E Manuel d'utilisateur Page 10