Ford SK5W7J-19A361-AA Manuel d'utilisateur télécharger pdf (Page 9)

9/42

SK5W7J-19A361-AA

2W7Z-16A901-AA

Rev Date- 8/29/05

MODULE PREPARATION

Place the supplied fuses into the power distribution

block on the control module. Refer to the fuse

placement drawing for the specific vehicle that you are

working on. Fuse placement drawings are located in

vehicle specific wiring sections.

In this diagram, the parking light fuse is shown in the

positive polarity position and the Dome light fuse is

shown in the negative polarity position.

Note: The HVAC1, HVAC2 and IGNITION fuses are only

used on systems including remote car start (requires

PC-32 module).

Place the software cartridge (DNA) onto the control

module as shown.

Plug the wiring harness(es) into the module.

Harness A: 24-way, used on all systems;

Harness B: 10-way, used on all systems with car start;

Harness C: 16-way, used on systems with convenience

features (i.e. Headlight control, memory seat control)

along with some preload system installations in vehicles

without factory equipped RKE.

If you are installing a system that uses the whip

antenna (RKE, RKE/VSS or Preload), plug the whip

antenna into the module at this time.

15 15

HVAC 1

HVAC 2

MAIN B+

IGNITION

DOME LIGHT

DRIVER DOOR UNLOCK/

TRUNK RELEASE

PK LIGHTS

DOOR LOCKS

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

Ford SK5W7J-19A361-AA Manuel d'utilisateur Page 9