Ford CRAFTSMAN F-150 Manuel d'utilisateur Page 9

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 8
K3033a-0920
9
BATTERY CHARGING
F
K3033a-0920
E
Battery
Connector
Charger
Connector
A
B
Plug the charger connector into the battery connector
A
. Push
firmly to make sure the connectors are completely joined.
Plug the charger into a standard wall outlet
B
.
Notes:
- Use the charger only in a wall outlet. Do not plug the AC adaptor
into a ceiling outlet.
- If power flow to the wall outlet is controlled by a switch, make sure
the switch is “ON”.
Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
Recharge the battery for at least 14 hours after each use of your
vehicle. Do not charge the battery longer than 30 hours.
Once the battery is charged, disconnect the battery connector from
the charger connector. Unplug the charger from the wall outlet. The
battery is now ready to be installed in your vehicle. Please see the
Battery Installation section on page 20 for detailed instructions on
installing your battery. If your battery is already installed in your
vehicle, simply re-connect the motor harness connector to the
battery connector.
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
not handle parts, including the battery, or
help in assembly of the vehicle.
ASSEMBLY
Place a .437 cap nut on a flat surface, inside up.
Fit the end of the rear axle into the cap nut.
Tap the opposite end of the rear axle with a hammer to secure the
cap nut on the rear axle. Pull on the cap nut to be sure it’s secure.
Rear Axle
.437 Cap Nut
1
.437"
INCORRECT
GAP
CORRECT
NO GAP
Vue de la page 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Commentaires sur ces manuels

Pas de commentaire