Ford W0029 Manuel d'utilisateur télécharger pdf (Page 22)

T6991a-0920

IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If

you still experience a problem, please contact Power Wheels

Consumer Relations, toll-free at 1-800-348-0751. Or,

contact your local Power Wheels

authorized service center. For the location nearest you, please visit us online at

www.powerwheels.com, or call 1-800-348-0751.

PROBLEMS AND SOLUTIONS

PROBLEM POSSIBLE CAUSE SOLUTION

Vehicle does not run Undercharged battery Charge the battery. A new battery should have been

charged for at least 18 hours before using the vehicle

for the  rst time. After  rst-time use, recharge the

battery for at least 14 hours after each use. Never

charge the battery longer than 30 hours.

Check all connectors. Make sure the charger

connector is plugged into the battery, and that the

charger is plugged into the wall.

Make sure power  ow to the wall outlet is “ON”.

Charger is not working There is no sure way to tell if your charger is working

unless you have a volt meter. If you suspect there

is a problem with your charger, contact your local

Power Wheels

authorized service center. They can

test your charger for you.

Tripped thermal fuse The built-in thermal fuse may “trip” and shut down

operation of the vehicle if the vehicle is overloaded

or the driving conditions too severe. Once a fuse

has “tripped”, remove your foot from the pedal and

wait approximately 25 seconds before operating

the vehicle again. To avoid repeated automatic

shutdowns, do not overload the vehicle by exceeding

the 130 lbs. (59 kg) maximum weight capacity or by

towing anything behind the vehicle. Do not drive up

hills or run into  xed objects, which can cause the

wheels to stop spinning while power is still being

supplied to the motors. If a thermal fuse continually

trips, contact your local Power Wheels

authorized

service center.

Loose wire or loose connectors Check all wires and connectors. Make sure the motor

harness connector is plugged into the battery, and

that there are no loose wires around the motors.

Dead battery If your battery is old or if you have not followed

Battery Care instructions, your battery may be dead.

If you are unsure whether or not the battery is dead,

you can have it tested at your local Power Wheels

authorized service center.

Electrical switch damage The electrical switches can become corroded due

to exposure to water or moisture, or can jam due

to loose dirt, sand or gravel. Contact your local

Power Wheels

authorized service center for

diagnosis and repair.

Motor damage Contact your local Power Wheels

authorized service

center for diagnosis and repair.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Commentaires sur ces manuels

Pas de commentaire

Ford W0029 Manuel d'utilisateur Page 22

Commentaires sur ces manuels