Ford F-150 K8285 Manuel d'utilisateur Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
K8285a-0920
14
BACK VIEW
Insert the "T" fastener end of a short seat belt strap through the
slot near the outer edge of the seat. Make sure the fastener side
of the seat belt faces inward.
Note: You will pull only one T-Loop through the slot.
Repeat this procedure to assemble the other short seat belt strap.
Insert each fastener end of the long seat belt strap through the
slots in the center of the seat. Make sure the fasteners face the
outer edge of the seat.
Pull each side of the long seat belt strap evenly through the slots.
Make sure to pull each T-loop through a slot.
Turn the vehicle upright.
Insert both tabs on the back edge of the seat into the slots inside
the bed.
22
Short Seat Belts
Long Seat Belt
Insert two screws through the back of the seat and into the vehicle.
Tighten the screws.
24
23
Slots
Seat
Align the tabs on a hubcap with the slots in a rear wheel. “Snap”
a hubcap into the center of the rear wheel.
Hint: If the hubcap does not "snap" into place, you may not have
assembled the wire clip properly. Remove the wire clip and refer
back to step 18.
Repeat steps 17 - 21 to assemble the other rear wheel, wire clip
and hubcap.
21
Hubcap
Screws
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Commentaires sur ces manuels

Pas de commentaire