Ford 2009 Explorer Sport Trac v.2 Manuel d'utilisateur télécharger pdf (Page 120)

Keyless entry keypad procedure

1. Turn the ignition to the off position.

2. Close all doors.

3. Enter 5–digit entry code

4. Press and hold the 3 • 4. While holding the 3 • 4pressthe7• 8.

5. Release the 7 • 8.

6. Release the 3 • 4.

The user should receive a horn chirp to indicate the system has been

disabled or a chirp followed by a honk to indicate the system has been

enabled.

Message center procedure

For information on activating/deactivating the autolock feature using the

vehicle’s message center (if equipped), refer to Message center

information in the Driver Controls chapter.

Autounlock

The autounlock feature will unlock all the doors when:

• the ignition is in the on position, all the doors are closed, and the

vehicle has been in motion at a speed greater than 12 mph (20 km/h);

• the vehicle has then come to a stop and the ignition is turned to the

off or accessory position; and

• the driver door is opened within 10 minutes of the ignition being

transitioned to the off or accessory position.

Note: The doors will not autounlock if the vehicle has been

electronically locked before the driver door is opened.

Deactivating/activating autounlock

Your vehicle comes with the autounlock feature activated. There are four

methods to enable/disable this feature:

• Through your authorized dealer, or

• Performing the power door lock control procedure, or

• Performing the keyless entry keypad (if equipped) procedure, or

• Performing the message center (if equipped) procedure.

Before following the activation or deactivation procedures, make sure

that the anti-theft system is not armed, ignition is in the off position, and

all vehicle doors are closed.

2009 07+ Explorer Sport Trac (esp)

Owners Guide, 2nd Printing

USA (fus)

Locks and Security

120

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 350 351

Pas de commentaire

Ford 2009 Explorer Sport Trac v.2 Manuel d'utilisateur Page 120