Ford 2009 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 93)

1. Start the vehicle.

2. Locate the reset button on the compass sensor mounted on the base

of mirror.

3. To calibrate, press and hold the

reset button on the compass module

for approximately eight seconds and

release.

4. Slowly drive the vehicle in a

circle (less than 3 mph [5 km/h])

until the CIRCLE SLOW TO CALIBRATE display changes to

CALIBRATION COMPLETED. It will take up to five circles to complete

calibration.

5. The compass is now calibrated.

System warnings

System warnings alert you to possible problems or malfunctions in your

vehicle’s operating systems.

In the event of a multiple warning situation, the message center will

cycle the display to show all warnings by displaying each one for four

seconds.

The message center will display the last selected feature if there are no

more warning messages. This allows you to use the full functionality of

the message center after you acknowledge the warning by pressing the

RESET control and clearing the warning message.

Warning messages are divided into four categories:

• They cannot be cleared until the condition is corrected.

• They will reappear on the display 10 minutes from the reset if the

condition has not been corrected.

• They will not reappear until an ignition off-on cycle has been

completed.

• They reappear if the condition clears then reoccurs within the same

ignition on-off cycle.

This acts as a reminder that these warning conditions still exist within

the vehicle.

2009 07+ Explorer Sport Trac (esp)

Owners Guide, 1st Printing

USA (fus)

Driver Controls

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 355 356

Pas de commentaire

Ford 2009 Explorer Sport Trac v.1 Manuel d'utilisateur Page 93