Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 91)

To remove the cargo cage:

1. Extend the cargo cage.

2. Pull the lever on each side of the

cage to unlock it.

Make sure the locking clip screws

are loose before removing the cargo

cage.

3. Press the locking clips below the

middle bar and lift the cargo cage

out of the channels on the “D” pillar.

To install the cargo cage, follow the removal procedure in reverse order.

TONNEAU COVER (IF EQUIPPED)

The tonneau cover has been designed to maximize fuel economy and

should be fully installed whenever possible.

The rear panel can be folded in half and secured behind the cab, or the

whole cover can be removed completely from the vehicle.

To avoid damage to the cover, do not operate the vehicle unless

the cover is fully installed and securely latched, or securely

stowed.

To avoid damage to the cover, do not stand, sit or load anything

on top of the cover.

The tonneau cover has been designed to be a water resistant system. A

small amount of water may drain into the pickup box with the cover

installed.

To open the front panel:

• Open the driver side lock cover

and unlock the front panel using

the Tonneau cover key.

• Lift the panel to access items in

the pickup box near the cab.

• To close, lower the panel down

on the pickup box.

Do not drive with front panel

unlocked or folded on top of the

rear panel.

2007 07+ Explorer Sport Trac (esp)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 311 312

Pas de commentaire

Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur Page 91