Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 73)

Compass calibration adjustment

Perform compass calibration in an open area free from steel structures

and high voltage lines. For optimum calibration, turn off all electrical

accessories (heater/air conditioning, wipers, etc.) and make sure all

vehicle doors are shut.

1. Start the vehicle.

2. Locate the reset button on the compass sensor mounted on the base

of mirror.

3. To calibrate, press and hold the

reset button on the compass module

for approximately eight seconds and

release.

4. Slowly drive the vehicle in a

circle (less than 5 km/h [3 mph])

until the CIRCLE SLOW TO CALIBRATE display changes to

CALIBRATION COMPLETED. It will take up to five circles to complete

calibration.

5. The compass is now calibrated.

System warnings

System warnings alert you to possible problems or malfunctions in your

vehicle’s operating systems.

In the event of a multiple warning situation, the message center will

cycle the display to show all warnings by displaying each one for 4

seconds.

The message center will display the last selected feature if there are no

more warning messages. This allows you to use the full functionality of

the message center after you acknowledge the warning by pressing the

RESET control and clearing the warning message.

Warning messages are divided into four categories:

• They cannot be cleared until the condition is corrected.

• They will reappear on the display ten minutes from the reset if the

condition has not been corrected.

• They will not reappear until an ignition OFF-ON cycle has been

completed.

2007 07+ Explorer Sport Trac (esp)

Owners Guide (post-2002-fmt)

USA (fus)

Driver Controls

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 311 312

Pas de commentaire

Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur Page 73