Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 106)

Deactivating/activating autounlock

Your vehicle comes with the autounlock feature activated. There are four

methods to enable/disable this feature:

• Through your authorized dealer, or

• Performing the power door lock control procedure, or

• Performing the keyless entry key pad (if equipped) procedure, or

• Performing the message center (if equipped) procedure.

Before following the activation or deactivation procedures, make sure

that the anti-theft system is not armed, ignition is in the 1 (OFF/LOCK)

position, and all vehicle doors are closed.

Power door unlock/lock procedure

You must complete Steps 1-5 within

30 seconds or the procedure will

have to be repeated. If the

procedure needs to be repeated,

you must wait 30 seconds. Note:

All doors must be closed and

remain closed throughout the

configuration process.

1. Turn the ignition to the 3 (ON) position.

2. Press the power door unlock control three times.

3. Turn the ignition from the 3 (ON) to the 1 (OFF/LOCK) position.

4. Press the power door unlock control three times.

5. Turn the ignition back to the 3 (ON) position. The horn will chirp.

6. Press the lock control, then press the unlock control. The horn will

chirp once if autounlock was deactivated or twice (one short and one

long chirp) if autounlock was activated.

7. Turn the ignition to the 1 (OFF/LOCK) position. The horn will chirp

once to confirm the procedure is complete.

Keyless entry key pad procedure

1. Turn the ignition to the 1 (OFF/LOCK) position.

2. Close all doors.

3. Enter 5–digit entry code

Press and hold the 3 • 4. While holding the 3 • 4 press the 7 • 8 twice.

5. Release the 7 • 8.

2007 07+ Explorer Sport Trac (esp)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 311 312

Pas de commentaire

Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur Page 106