Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 104)

To lock all doors, press the 7 • 8 and the 9 • 0 at the same time.

Note: The driver’s door must be closed. You do not need to enter the

keypad code first.

Autolock

The autolock feature will lock all the doors when:

• all doors are closed,

• the ignition is in the 3 (ON) position,

• you shift into any gear putting the vehicle in motion, and

• the vehicle attains a speed greater than 12 mph (20 km/h).

The autolock feature repeats when:

• any door is opened then closed while the ignition is in the 3 (ON)

position and the vehicle speed is 9 mph (15 km/h) or lower, and

• the vehicle attains a speed greater than 12 mph (20 km/h).

Deactivating/activating autolock

Your vehicle comes with the autolock feature enabled. There are four

methods to enable/disable this feature:

• Through your authorized dealer, or

• Performing the power door lock control procedure, or

• Performing the keyless entry key pad (if equipped) procedure, or

• Performing the message center (if equipped) procedure.

Note: The autolock feature can be activated/deactivated independently

of the autounlock feature.

Before following the activation or deactivation procedures, make sure

that the anti-theft system is not armed, ignition is in the 1 (OFF/LOCK)

position, and all vehicle doors are closed.

Power door unlock/lock procedure

You must complete Steps 1-5 within

30 seconds or the procedure will

have to be repeated. If the

procedure needs to be repeated,

you must wait 30 seconds. Note:

All doors must be closed and

remain closed throughout the

configuration process.

1. Turn the ignition to the 3 (ON) position.

2007 07+ Explorer Sport Trac (esp)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

104

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 311 312

Pas de commentaire

Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur Page 104