Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur télécharger pdf (Page 103)

3. Enter your personal 5-digit code. Each number must be entered

within five seconds of each other.

4. Press 1 • 2, 3 • 4or5• 6 to indicate which of the three personal

entry code positions you wish to use.

5. The doors will again lock then unlock to confirm that your personal

key code has been programmed to the module.

Tips:

• Do not set a code that uses five of the same number.

• Do not use five numbers in sequential order.

• The factory set code will work even if you have set your own personal

code.

• If you program a code to a position that already contains a set code,

the previously-set code will be erased.

Erasing personal code

1. Enter the factory set 5–digit code.

2. Within five seconds, press the 1 • 2 on the keypad and release.

3. Press and hold the 1 • 2 for two seconds. This must be done within

five seconds of completing Step 2.

All personal codes are now erased and only the factory set 5–digit code

will work.

Anti-scan feature

If the wrong code has been entered 7 times (35 consecutive button

presses), the keypad will go into an anti-scan mode. This mode disables

the keypad for one minute and the keypad lamp will flash.

The anti-scan feature will turn off after:

• one minute of keypad inactivity.

• pressing the UNLOCK

control on the remote entry transmitter.

• the ignition is turned to the 3 (ON) position.

Unlocking and locking the doors using keyless entry

To unlock the driver’s door, enter the factory set 5-digit code or your

personal code. Each number must be pressed within five seconds of each

other. The interior lamps will illuminate.

To unlock all doors, press the 3 • 4 control within five seconds.

2007 07+ Explorer Sport Trac (esp)

Owners Guide (post-2002-fmt)

USA (fus)

Locks and Security

103

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 311 312

Pas de commentaire

Ford 2007 Explorer Sport Trac v.1 Manuel d'utilisateur Page 103