Ford AM/FM stereo Manuel d'utilisateur télécharger pdf (Page 89)

Deactivating/activating the BeltMinder feature

Read steps1-5thoroughly before proceeding with the

deactivation/activation programming procedure.

The BeltMinder feature can be deactivated/activated by performing the

following procedure:

Before following the procedure, make sure that:

• the parking brake is set

• the gearshift is in P (Park) (automatic transmission)

• the ignition switch is in the OFF position

• all vehicle doors are closed

• the driver’s safety belt is unbuckled

• the parklamps/headlamps are in OFF position

To reduce the risk of injury, do not deactivate/activate the Belt

Minder feature while driving the vehicle.

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT

START THE ENGINE)

2. Wait until the safety belt warning light turns off. (Approximately 1

minute)

• Step 3 must be completed within 50 seconds after the safety belt

warning light turns off.

3. Buckle then unbuckle the safety belt 9 times, ending with the safety

belt in the unbuckled state.

• After step 3 is complete, the airbag warning light will be turned on for

3 seconds.

• Beltminder will automatically exit programming mode without

changing its enable status if step 4 does not occur within 10 seconds

of the end of step 3.

4. Within 10 seconds of the light turning on, buckle then unbuckle the

safety belt.

• This will disable the BeltMinder feature for that seating position if it is

currently enabled. As confirmation, the airbag warning light will flash

4 times per second for 3 seconds.

• This will enable the BeltMinder feature for that seating position if it is

currently disabled. As confirmation, the restraint system warning light

2004 Econoline (eco)

Owners Guide (post-2002-fmt)

USA English (fus)

Seating and Safety Restraints

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 247 248

Ford AM/FM stereo Manuel d'utilisateur Page 89